Qmb Channel Programming/Recall - Yaesu FT-100D Operating Manual

Memory System Operation
QMB
CHANNEL PROGRAMMING/RECALL
QMB
CHANNEL STORAGE
1. Tune in the desired frequency and set the operating mode and bandwidth.
2. Press and hold in the [VFO/MR] key for
~
second until a double "beep" is heard. The
double beep provides audible confIrmation that the memory storage into QMS channel
"QMB 001" was successful.
3. As you store other frequencies into QMS memories, the latest data is stored into memory
register "QMB 001", and the data previously stored into channel "QMB 001" is shifted
to channel "QMB 002", the data previously stored into "QMB 002" is stored into
"QMB 003", and so forth. When all fIve QMS memories are full, and you store a new
frequency, the data stored in channel "QMB 005" will be purged.
Frequency data will be stored and purged on a fIrst-in, fIrst-out basis.
QMB
CHANNEL RECALL
1. Press the [FUNC] key, as needed, to recall Operating Function Row I [AlB, A=B, SPL,
QMB] then press the [D](QNB) key momentarily to recall the currently-active QMS
channel.
2. Press the [D](QNB) key repeatedly to cycle though the QMS channels, in the same
sequence as shown for QMS Channel Storage.
FT-100
MICRO MOBILE OPERATING MANUAL
69