Yaesu FT-100D Operating Manual page 90

Menu Operation
MENU MODE SELECTIONS AND SETTINGS
Menu Item 20
(BPF WIDTH]
Function: Setting the bandwidth for the DSP CW audio filter.
Available Values: 601120/240 Hz
Default: 240 Hz
This selection detennines the bandwidth of the DSP CW peaking filter.
Menu Item 21
(HF TX PO]
Function: Setting the maximum power level for the HF band.
Available Values: 0 - 100
Default: 100
fi ' . . , ' "
You can set the power output separately on SSBICWIFM and FM by chang-
"~
_ ing modes and re-adjusting this setting for the desired power level.
/ ..
Menu Item 22
(50M TX PO]
Function: Setting the maximum power level for the 50 MHz band.
Available Values: 0 - 100 % (% of 100 Watts maximum PO)
Default: 100
, , You can set the power output separately on SSBICWIFM and FM by chang-
~~
ing modes and re-adjusting this setting for the desired power level.
~
Menu Item 23
(144M TX PO]
Function: Setting the maximum power level for the 144 MHz band.
Available Values: 0 - 100 % (% of 50 Watts maximum PO)
Default: 100
, , You can set the power output separately on SSBICWIFM and FM by chang-
~~
ing modes and re-adjusting this setting for the desired power level.
~
Menu Item 24
(430M TX PO]
Function: Setting the maximum power level for the 430 MHz band.
Available Values: 0 - 100
%
(% of20 Watts maximum PO)
Default: 100
, , You can set the power output separately on SSBICWIFM and FM by chang-
ft ~.
' "
ing modes and re-adjusting this setting for the desired power level.
<;c;1-
/
88
FT-100
MICRO MOBILE OPERATING MANUAL