Amlfm Reception; Automatic Power·ottfeature - Yaesu FT-100D Operating Manual

Receiver Accessories
AM/FM RECEPTION
In the AM and FM modes, the
MAIN DIAL
is locked out (via a MENU setting) so as to
allow "channelized" tuning on these modes. To adjust the operating frequency, rotate the
SELECT
knob to change frequency in steps as set via the [STEP] key (see page 35).
If you wish to enable the
MAIN DIAL
for tuning in the AM and FM modes, change the
setting of MENU #58:
CD Press and hold in the [FUNC] key for Yz
second to enter the MENU mode.
~
Rotate the
SELECT
knob to recall MENU #58 (AM&FM CLICK).
Q)
Rotate the
MAIN DIAL
to set this feature ("AM&FM CLICK") to "Off."
@)
Press the [FUNC] key momentarily to save the new setting and exit to normal op-
eration.
AUTOMATIC POWER-OFF FEATURE
The FT -\ 00 includes an Automatic Power-Off (APO) feature, which will tum the radio off
after a user-defined amount of time. This can prevent your transceiver from draining your
car's battery, for example, if you forget to tum the transceiver off when leaving the car.
To enable and program the APO feature:
CD Press and hold in the [FUNC] key for Yz
second to enter the MENU mode.
~
Rotate the
SELECT
knob to recall MENU #29 (A PO TIME).
Q)
The default value for the APO feature is "Off." Rotate the
MAIN DIAL
to select \
hour, 2 hours, or 3 hours of operation before the radio automatically shuts off.
@)
Press the [FUNC] key momentarily to save the new setting and exit to normal op-
eration.
Once you have programmed a time interval, the APO countdown timer will start whenever
some front panel action (tuning, transmission, etc.) ends. Ifthere is no action by you within
the time interval programmed, the microprocessor will shut down the radio automatically.
Just press and hold in the [PWR] switch for
Yz
second to tum it back on, as usual.
46
FT-100
MICRO MOBILE OPERATING MANUAL