Yaesu FT-100D Operating Manual page 88

Menu Operation
MENU MODE SELECTIONS AND SETTINGS
Menu Item
10
[CW 10)
Function: Enables/disables the CW identifier during ARTS operation.
Available Values: on/oFF
Default: oFF
Menu Item
11
(10)
Function: Store the CW Identifier ca\lsign. Up to 8 characters may be stored. The storage
procedure is as follows:
1. Press the SELECT knob momentarily to initiate the CW ID storing.
2. Rotate the MAIN DIAL to select the frrst letter/number of your callsign, then press the
SELECT knob momentarily to save the first letter/number and move to next entry
place.
3. Repeat the previous step as necessary to complete your callsign.
4. Press the [FUNC] key to save your completed ca\lsign and exit.
Menu Item
12
[TONE FREQ)
Function: Setting the CTCSS Tone Fre-
quency.
Available Values: 39 standard CTCSS
tones.
Default: 88.5 Hz
The available tones are shown in the chart.
Menu Item
13
[DIMMER SET)
Function: Setting the degree of dimming of the front panel display's brightness.
Available Values: 63 (Dim)
~
1 (Bright)/oFF(Brightest)
Default: oFF (Brightest setting)
Menu Item
14 [PEAK
HOLD)
Function: Enabling/Disabling of the "Peak-Hold (0.5 second hold)" function ofthe meter.
Available Values: on/oFF
Default: oFF
Menu Item
15
[SCOPE MONI)
Function: Select the sweep mode for the SPECTRUM SCOPE feature.
Available Values: Cont/CHEC/SgLloFF
Default: oFF
ContThe scanner sweeps continuously.
Chec: The scanner sweeps one cycle every 30 seconds.
SgL: The scanner sweeps just once.
oFF: The scanner is disabled.
86
FT-JOO
MICRO MOBILE OPERATING MANUAL