Spectrum Scope Operation - Yaesu FT-100D Operating Manual

Spectrum Scope Operation
The
SPECTRUM SCOPE
allows viewing of operating activity on 15 channels above and 15
channels below the current operating channel. The
SPECTRUM SCOPE
is available in the
SSB/
AM/FM
modes.
To activate the
SPECTRUM SCOPE:
I. Press and hold in the [FUNC] key for
I;i
second to enter the
MENU
mode, then rotate the
SELECT knob to select
MENU
# 15 (SCOPE MONI).
2. Rotate the MAIN DIAL to select the desired sweep mode:
Cant: The
SPECTRUM SCOPE
sweeps continuously.
Chec: The
SPECTRUM SCOPE
sweeps one cycle every 30 seconds.
Sgl: The
SPECTRUM SCOPE
sweeps just once whenever you press the [FUNC]
key.
oFF: The
SPECTRUM SCOPE
is disabled.
3. Press the [FUNC] key momentarily to start the
SPECTRUM SCOPE.
4. When the scope is in operation, the relative signal strength of stations on channels
immediately adjacent to the current frequency will be indicated on the display.
To disable the
SPECTRUM SCOPE,
select the "oFF" option in step 2 (above).
'~'
, '" 0 In the FM and AM modes, the
SPECTRUM SCOPE
sweeps in increments
~
_ corresponding to the current VFO step. In the SSB mode, the
SPECTRUM
/ ' < :1
SCOPE
utilizes 2.5 kHz steps.
o
The receiver's audio output and S-meter are disabled when using the
SPECTRUM
SCOPE.
76
FT-JOO ~[ICRO MOBILE OPERATING MANUAL