Menu Mode Selections And Setting - Yaesu FT-100D Operating Manual

Menu Operation
MENU MODE SELECTIONS AND SETTINGS
Menu Item 01 [DIAL PULSE)
Function: Setting of MAIN DIAL Speed.
Available Values: 100/200
Default: 200
You may choose between two speeds for the MAIN DIAL knob. Selecting" 1 00" cuts the
tuning rate in half compared to the default value.
Menu Item 02 [BEEP)
Function: Enables/disables the key and button beeper.
Available Values: on/oFF
Default: on
Enables/disables the beep that sounds when a front panel key or button is pressed.
Menu Item 03 [SCAN MODE)
Function: Select the desired Scan-Resume mode.
Available Values: tinElbuSy/StoP
Default: tinE
This Menu Item allows you to select your favorite method of scan-restart after the scanner
has stopped on an incoming signal (when the squelch opens). The choices are:
tinE: The scanner will hold for a fixed length of time, set via Menu Item 05, then
resume whether or not the other station is still transmitting.
buSy: The scanner will hold until the signal disappears, then will resume after one
second.
StoP: The scanner will stop when a signal is received, and will not restart.
Menu Item 04 [SCAN SPEED)
Function: VFO Scan Speed.
Available Values: 10 ~ 100 ms
Default: 10 ms
This sets the scan dwell time (the time spent on each synthesizer step) during VFO scan-
ning. This setting is enabled in the SSB, CW, and DIG modes only.
Menu Item 05 [RESUME)
Function: Set the delay time for scan, as described in Menu Item 03.
Available Values: I - 10 second
Default: 5 second
This Menu Item defines the length of time the scanner will hold on a frequency when in the
"tinE" mode.
84 FT-JOO
MICRO MOBILE OPERATING MANUAL