Dtmf Operation; Artstm(Auto Range Transpond System) Operation; Cw Identifier Setup - Yaesu FT-100D Operating Manual

Transmitter Operation
FM
OPERATION
DTMF OPERATION
When using the optional MH-368SJS DTMF microphone, you can manually send out
DTMF tones for autopatch or repeater control purposes.
In the FM mode, close the microphone's PTT switch, as usual. While holding in the PTT
switch, press the keys corresponding to the tones you wish to send. When you are finished,
after releasing the final DTMF key, you may release the PTT switch.
ARTSTM (AUTO RANGE TRANSPOND SYSTEM) OPERATION
The ARTS™ system uses DCS signaling to inform you when you and another ARTS-
equipped station are within communications range.
/. Press the [FUNC] key, as needed, to recall Operating Function Row 3 [TON, DCS,
ART].
2. Press the [C](ART) key to activate the ARTS feature (the "ART" icon will appear on
the display).
Your display will change to "out rng" to indicate the beginning of ARTS operation.
Every 15 seconds, your radio will transmit a "polling" call to the other station. When
that station responds with its ARTS polling signal, your display will change to "in rng"
to confirm his response.
3.
To cancel ARTS operation, press the [C](ART) key again (the "ART" icon will disap-
pear from the LCD).
~ '
...... '... The ARTSfeature offers a choice ofbeep options to alert you to the current
, ... />
iE!l
status of ARTS operation. Check out
MENU
#09 (ARTS BEEP) on page 85.
<.:d-
/
CW
IDENTIFIER SETUP
The ARTS feature includes a CW identifier. The radio can be instructed to send "DE (your
cal/sign)
K" in Morse code every ten minutes during ARTS operation.
To program the CW IDer, use MENU #11 (ID), as described on page 86. And to activate the
CW IDer, use MENU # I 0 (CW 10).
FT-JOO
MICRO MOBILE OPERATING MANUAL
57