Tuning Speed Selection; General Coverage I Mhz Frequency Steps; General Coverage 10 Mhz Frequency Steps; Stacked Vfo System - Yaesu FT-100D Operating Manual

Receiver Operation
TUNING SPEED SELECTION
The rate at which the MAIN DIAL causes frequency change is determined, in part, by the
number of "steps" per revolution of the dial. The stepping rate may be doubled (or cut in
half) via the following procedure:
1. Press and hold in the [FUNC] key for
Y:z
second to activate the "Menu" command
mode.
2. Rotate the SELECT knob until MENU #01 is found.
3. Rotate the MAIN DIAL to choose the desired tuning speed. The default value is "200,"
and selecting" 1 00" will cut the tuning rate in half.
4. Press the [FUNC] key momentarily to save your new setting and exit to normal opera-
tion.
It ' . . . ' / '
The section just described allows you to change the number of "steps" per
~
_ revolution of the MAIN DIAL
If
you want to choose larger or smaller steps,
~ ~
go back to the section before this one, entitled "Frequency Synthesizer Steps."
GENERAL COVERAGE
1 MHz
FREQUENCY STEPS
1. Press the SELECT knob momentarily, then rotate the SELECT knob to change fre-
quency in I MHz increments.
2. To return to normal steps, again press the SELECT knob momentarily.
GENERAL COVERAGE
1 0 MHz
FREQUENCY STEPS
Especially when navigating over the VHF and UHF bands, you may find it more efficient
to move in 1
a
MHz steps, so as to get to the desired frequency more quickly.
I. Press and hold the SELECT knob for Y2 second, then rotate the SELECT knob to
change Frequency in 10 MHz increments.
2. To return to normal steps, again press and hold in the SELECT knob for
Y:z
second.
It ' .' / '
To help you remember the procedure for large frequency excursions:
~
• press the SELECT knob a short time for a "short" step
(1
MHz);
~
-
~
. .
• press the SELECT knob a longer time for a "longer" step (10 MHz).
36
FT-IOO
MICRO MOBILE OPERATING MANUAL