Scan Skip Programming (Memory Mode Only) - Yaesu FT-100D Operating Manual

Scanning Operation
SCAN SKIP PROGRAMMING (MEMORY MODE ONLY)
Among the memories you have programmed, there may be some stations which you do not
wish to scan. For example, weather broadcasts (which are transmitted continuously) will
cause the scanner to stop, and such channels may be skipped so as to avoid this inconve-
nience.
To remove a channel from the scanning loop:
I. Recall the memory channel to be skipped.
2. Press the [FUNC] key, as needed, to recall Operating Function Row 4 [SKP, SCN,
OW, SCH], then press the [A](SKP) key momentarily. The "SKP" icon will become
Bold; this shows that this channel is now not included in the scanning loop.
3. Repeat steps I and 2 as many times as necessary to skip all the channels you do not
wish to scan.
4. Initiate memory scanning, you will observe that the channels you marked to be skipped
are not included in the scanning loop.
5. Press the PTT switch to stop the scan; you may now use the SELECT knob to step
through the channels manually - one at a time - and you will observe that the "skipped"
channels are, nonetheless, available for recall by manual means.
6. You may restore a previously-skipped channel to the scanning loop by selecting the
channel manually, then pressing the [A](SKP) key momentarily so that the "SKP" icon
becomes faint.
FT-100
MICRO MOBILE OPERATING MANUAL
79