Yaesu FT-100D Operating Manual page 27

Front Panel Controls and Switches
@LOCKKey
Pressing this key locks the MAIN DIAL, so as to prevent accidental frequency change.
@MAINDIAL
This is the main tuning dial for the transceiver. It is used both for frequency tuning as
well as
"MENU"
setting in the FT-IOO.
t]) FUNC Key
The "Function" key is used to select one of the nine operations available on each of the
[A], [B], [C], or [D] keys. These keys are located below the LCD (display).
@MODEKey
Pressing this key repeatedly allows selection of the operating mode. The selections
available are:
SSB (lSB or USB)
-7
CW
-7
AM
-7
FM
-7
SSB (lSB or USB) ...
Pressing and holding in this key for Y2 second allows toggling of modes within a mode
group (lSB
~
USB, CW
~
CW-R [Reverse], AM
~
DIG, and FM
~
W[Wide]-FM).
@ UP/OWN Keys
Pressing one of these keys momentarily wiII cause the frequency to be moved up or
down by one Amateur band.
@) DSP Key
Pressing this key momentarily provides instant access to Operating Function Row 9,
which contains the command keys for the receiver's Digital Signal Processing system.
The available functions will appear as the functions displayed above the [A]
~
[D]
keys, described below.
@FUNCKey
These four keys select many of the most important operating features of the FT-IOO.
Above each of the [A]
~
[D] keys (along the bottom of the LCD) is a label describing
the current function of that key; pressing the FUNC key repeatedly scrolls the display
through nine rows offunctions available for use via the [A]
~
[D] keys.
The available features are shown in the chart below.
FT-JOO
MICRO MOBILE OPERATING MANUAL
25