Setting The Template Items; Memory; Memories; Skip - Yaesu FT-70DR Instruction Manual

Setting the Template Items

Memory

Use this page to edit the Memory channels data, Skip Memory channels, or PMS (Programmable Memory
Scan) memory channels.

• Memories

Enter and edit the frequencies you normally use to the memory channels. Up to 900 channels can be
registered.

• SKIP

When scanning the VFO, if there are frequencies with continuous signals, scanning may be interrupted.
Up to 99 channels can be registered.

• PMS

Edit the upper and lower limit frequencies for performing PMS (Programmable Memory Scan).
Enter the lower limit frequency for the L channel and the upper limit frequency for the corresponding U
channel. Up to 50 pairs (100 channels) of PMS can be registered.

About the setting items of each memory channels

• Priority CH

While Dual Watch is functioning, this channel is designated as the priority channel to be monitored be-
fore other channels. Only one normal memory channel can be set as Priority CH. Tick the checkbox of
the desired channel.
This setting is allowed only with the normal memory channel.

• Receive Frequency/ Transmit Frequency

Enter the desired receive/transmit frequency. When the frequency entry is complete, use the → key to
move the cursor to the right and subsequently configure the additional detail settings for the channel. To
enter the transmit frequency for the next channel, press the ENTER or ↓ key. The receive and transmit
frequencies can be set separately.

• Offset Frequency

When a transmit frequency is not entered, transmission will be performed at a frequency obtained by
adding/subtracting the offset frequency to/from the receive frequency.
ADMS - 10 Instruction Manual
20