Memory Operation; Memory Storage; Memory Recall; Changing Memory Frequency - Yaesu FT-767GX Operating Manual

4.9 Memory Operation
4.9.1 Memory Storage
(1) Set the VFO to the frequency and mode
of emission to be stored.
(5) Press the MCK key again to return the
display to the VFO after confirming
that the desired data has been stored
(and is now displayed).
Notice that steps (2), (3) and (5) are re-
quired only to select the memory channel that
is to be written.
CAUTION: If only the VFO-M key is pressed
when operating on a VFO, the selected fre-
quency and mode will be instantly written
into the last selected memory. In any
case, storing a memory overwrites all data
previously stored in that channel.
4.9.2 Memory Recall
1f you do not wish to preserve the VFO data,
but do wish to save the memory data, press the
M-VFO key to copy the memory channel data to
the VFO. This leaves the memory data intact,
but overwrites all data in the VFO.
Otherwise, if you wish to preserve the VFO
data but do not care to save the memory, press
the VFOB&M key to swap the memory and VFO.
=eDé =