Using The Default Setup - DAKOTA ULTRASONICS MMX-7 Operation Manual

Data logging ultrasonic thickness gauge

Hide thumbs Also See for MMX-7:

Table of Contents

Dakota Ultrasonics

11.5 Using the Default Setup

The default setup feature was added to the MMX-7 to use, as a last resort, if there

are no setups stored in the gauge –factory or otherwise. The only time this might

possibly occur is if the setup file in the MMX-7 was somehow corrupted, and the user

does not have access to a computer to re-load the factory setups back into the MMX-

7. This gives the user the ability to load and modify a basic setup as follows:

Note: The default file contains no probe zero data. Therefore, a zero must be

performed after loading. Also, the default setup can be loaded when using the flaw

mode feature, to eliminate the probe zero delay value, and start at the initial pulse or

zero.

1) Press the MENU key once to activate the menu items tab. Press the MENU

key multiple times to tab right and the ESC key multiple times to tab left until

the SETUP menu is highlighted and displaying the submenu items.

2) Use the UP and DOWN arrow keys to scroll through the sub menu items

until DEFAULT SETUP is highlighted.

3) Finally, press the MEAS key to return to the measurement screen.

Default Setup

Table of Contents