Probe Zero & Calibration - DAKOTA ULTRASONICS MMX-7 Operation Manual

3) Press the ENTER key to display the table/list of transducers.
4) Use the UP and DOWN arrow keys to highlight the transducer type currently
connected to the gauge.
5) Press the ENTER key to load the transducer type and display the
confirmation screen.
6) Press the OK key to overwrite the existing probe type, or ESC to cancel.
2.3 Probe Zero & Calibration
The next steps are to perform a probe zero and calibrate the MMX-7 to the material
and transducer selected. If the sound velocity is unknown, the MMX-7 can be
calibrated to a known thickness sample. The procedures are outlined as follows:
MMX-7 Ultrasonic Thickness Gauge
5