Dynex Agility Automated ELISA System Operator's Manual page 2

Revision History
Manual Version
Revision E For operation with Agility software
This publication is for the operators of the DYNEX Agility Automated Microplate
Processing System. Due to continuing software improvement, dialog boxes displayed in
this manual may differ from those actually seen in the software screens. Every effort has
been made to ensure the information in this manual is accurate, updated and consistent
with the product it describes. DYNEX reserves the right to make technical improvements to
the system and documentation without prior notice as part of a continuous program of
product development.
The information in this manual is of a proprietary nature. No part of this publication may be
reproduced, stored in a retrieval system, translated, transcribed, or transmitted in any form
or by any means without prior written permission of DYNEX.
DYNEX does not assume liability for the use of this manual. If the system is not used
according to the description in this manual DYNEX does not assume responsibility for any
consequent effects.
This manual supersedes all previous editions and is published by DYNEX Technologies,
Inc.
Questions or comments regarding the content of this manual can be directed to the
address below or to your supplier.
© 2009, Dynex Technologies, Inc.
DYNEX Technologies, Inc.
14340 Sullyfield Circle
Chantilly, VA 20151 USA
Revision Date:
November 2014
Dynex Technologies Limited
Unit B2
Yeoman Gate, Yeoman Way
Worthing, West Sussex
BN13 3QZ UK