Mitsubishi Electric MELSEC iQ-F Series User Manual page 161

Programmable controller
Hide thumbs Also See for MELSEC iQ-F Series:
Table of Contents

Advertisement

■Details of interface status
Bit
Description
0 to 3
Interface Configuration Status
4
Mcast Pending
5 to 31
Reserved
■Details of interface capability flag
Bit
Description
0
BOOTP Client
1
DNS Client
2
DHCP Client
3
DHCP-DNS Update
4
Configuration Settable
5
Hardware Configurable
6
Interface Configuration Change
Requires Reset
7
AcdCapable
8 to 31
Reserved
■Details of interface control flag
Bit
Description
0 to 3
Configuration Method
4
DNS Enable
5 to 31
Reserved
■IP multicast address setting value
Value
Description
0
The default assignment algorithm is used to create multicast addresses.
1
Multicast addresses are assigned according to the values specified for Num Mcast and Mcast Start Addr.
2
Reserved
Instance service
Service code
01H
0EH
10H
Value
Fixed to 2 (to set the IP address acquired from the parameter settings)
• 0: No changes to TTL Value and Mcast Config
• 1: In the wait-for-restart state due to changes to TTL Value and Mcast Config
Fixed to 0
Value
Fixed to 0 (because the BOOTP setting is not supported)
Fixed to 0 (because the name resolution setting with DNS is not supported)
Fixed to 0 (because IP address setting with DHCP is not supported)
Fixed to 0 (because the host name sending setting with DHCP requests is not supported)
Fixed to 0 (because Interface Configuration attribute setting is not supported)
Fixed to 1 (available for IP addresses set with parameters)
Fixed to 0 (because Interface Configuration attribute setting is not supported)
Fixed to 0 (because the address duplication detection setting is not supported)
Fixed to 0
Value
Fixed to 0 (to use IP addresses set with parameters)
Fixed to 0 (because the name resolution setting with DNS is not supported)
Fixed to 0
Service
Get_Attributes_All
Get_Attribute_Single
Set_Attribute_Single
Appendix 5 Details of Message Communication Support Command
A
APPX
159

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fx5-enet/ip

Table of Contents