Mitsubishi Electric MELSEC iQ-F Series User Manual page 82

• When "Ethernet Link" is selected for "Object"
Item
General Interface Speed
Link Status
Duplex Mode
Negotiation Status
Manual Setting Requires Reset
Local Hardware Fault
Physical Address
802.3 Link Auto-negotiate
Forced Duplex Mode
Forced Interface Speed
Interface Type
Interface State
Admin State
Interface Label
Input Octets
Ucast Packets
NUcast Packets
Discards
Errors
In Unknown Protocols
Output Octets
Ucast Packets
NUcast Packets
Discards
Errors
Error Counters Alignment Errors
FCS Errors
Single Collisions
Multiple Collisions
SQE Test Errors
Deferred Transmissions
Late Collisions
Excessive Collisions
MAC Transmit Errors
Carrier Sense Errors
Frame Too Long
MAC Receive Errors
8 EtherNet/IP Configuration Tool for FX5-ENET/IP
80
8.1 Window Structure
Description
Displays the communication speed of EtherNet/IP communications.
Displays the link status of EtherNet/IP communications.
Displays the communication method (full-duplex/half-duplex) of EtherNet/IP communications.
Displays the auto-negotiation status.
• 0: Auto-negotiation being executed.
• 1: Auto-negotiation failed and operation in progress with the default communication speed and
method.
• 2: Communication method detection failed, but communication speed detection succeeded.
Operation in progress with the default communication method.
• 3: Auto-negotiation completed successfully.
• 4: Auto-negotiation unexecuted.
Displays the reflection method when communication settings are changed.
• 0: Immediate reflection after the change
• 1: Reflection after the reset of the FX5-ENET/IP
Displays the hardware failure status.
Displays the MAC address of the FX5-ENET/IP.
Displays whether auto-negotiation is enabled or disabled.
Displays the default communication method set when auto-negotiation is disabled.
Displays the default communication speed set when auto-negotiation is disabled.
Displays the communication interface type.
Displays the communication interface status.
Displays the administration status.
Displays the communication interface name. (label)
Displays the length of the received data. (Unit: Octets)
Displays the number of unicast packets received.
Displays the number of non-unicast packets (multicast or broadcast) received.
Among the received packets, displays the number of discarded packets.
Among the received packets, displays the number of packets that include error information. (Excluding
the number of discarded packets)
Among the received packets, displays the number of packets with unrecognizable protocols.
Displays the length of the sent data. (Unit: Octets)
Displays the number of unicast packets sent.
Displays the number of non-unicast packets (multicast or broadcast) sent.
Among the sent packets, displays the number of discarded packets.
Among the sent packets, displays the number of packets that include error information. (Excluding the
number of discarded packets)
Displays the number of frames received of which data length is not an octet integral multiple.
Displays the number of frames received for which FCS check errors occurred.
Displays the number of frames received for which single collisions occurred.
Displays the number of frames received for which multiple collisions occurred.
Displays the error count of the SQE test.
Displays the number of times that a sending delay occurred.
Displays the probability of collisions occurring.
Displays the number of times that excessive collisions occurred.
Displays the number of MAC frame transmission errors.
Displays the number of errors that occurred during carrier detection.
Displays the receive count of frames that exceeded the maximum size.
Displays the number of MAC frame reception errors.