Filling Tubes - Paytec Eagle User Manual

Filling tubes

The max. level of coins in each tube is configured by default for each coin type.
The max. level in each tube can be customized in Fn09 with a P6000, or with keypad.
Do NOT exceed the max. level set by Payment Technologies S.r.l.
From firmware rev.3.00 it is equally possible to set a "MAX FILL" level for each tube, that is the max. number of
coins that can be inserted in tubes in "FILL" mode (manual filling of tubes). This parameter has been inserted in
Fn09 and in the menu SETUP from keypad; the parameter is usually set on "0" (zero) and therefore ignored,
which means that the max. number of coins in FILL mode is the standard "max. coins" in Fn09.
Go to Fn09 for more details.
Tube filling procedure (EAGLE must be ON).
1. Press the Escrow lever and, while keeping it pressed, press A (Fig.2).
2. Release both Escrow lever and A: the message "FILL" is displayed.
3. Slowly insert the coins you wish to configure for each tube (see label on tube group). Coins will be
automatically routed into the right tubes.
Label
4. Once the max. level has been reached, no more coins are accepted (when a "max-FILL" value has been
set, once that value has been reached letter "f" is displayed associated to the letter of the tube which is
being filled)
5. If you wish to exit "FILL" mode, you can follow one of the following procedures:
•
press Escrow lever and press A;
•
wait 60 seconds timeout;
•
switch EAGLE OFF.
Press Escrow lever ...
Fig.2
8
FILL
... and A