Edit Machine Code From Keypad - Paytec Eagle User Manual

Edit machine code from keypad

Starting from f/w revision 1.11 you can read and/or edit the machine code from keypad on changegiver.
At the same time press ESCROW LEVER + C,
The following message is displayed:
Press F; the first half of the machine code is displayed.
The machine code (see Fn00) is made of 8 digits:
The code is divided into 2 halves:
Hxxxx
st
1 half:
Lyyyy
nd
2 half:
The two halves of the code are alternatively displayed whenever pressing
E
Press more than once to increase the code or
E B
Keep or pressed to accelerate increase/decrease.
F
Press to confirm the code set.
D
Press to go back to the message
How to exit the procedure: press ESCROW LEVER + C, wait 30 seconds in idle state or switch the device OFF.
CODE
xxxxyyyy
B
to decrease it.
CODE
without saving the code set.
76
.
F