Installing EAGLE on a Vending Machine (VM)
1. Cut power.
2. Unlatch the winglet and lower it (Fig.1A).
3. Press the release lever (Fig.1B) and pull the selector forward.
4. The two mounting holes are clearly visible on the back plate (Fig.1C).
5. Remove the selector from its supports, if you need to use the third mounting hole (Fig.1D).
Unplug the flat cable (Fig.1E) and remove the selector.
WARNING
Be careful when plugging/unplugging the selector connector. Keep the two side latches pressed when
plugging/unplugging the connector (Fig.1D); avoid rotating the connector because it might be damaged.
Fig.1C
Fig.1A
RELEASE
LEVER
Fig.1D
5
Fig.1B