Fn05 - Bill Values - Paytec Eagle User Manual

Fn05 – Bill values
Enter bill values when a bill validator in parallel mode has been connected.
When a bill validator MDB has been connected, you don't have to enter bill values (bills are controlled via protocol
MDB).
1^ Bill
Value
2^ Bill
Value 10,00
3^ Bill
Value 20,00
Some bill validators can work in "pulse" mode (the number of pulses transmitted to the output is proportional to
the USF programmed).
In this case, when setting bill no.1 its value must be the same as the USF programmed (read user guide of the
bill validator).
For PAYTEC bill validator in pulse mode the USF is € 5.00.
Bill validator models and logic level INH are set in Fn00.
Consult the bill validator user guide (on some models, you can modify configuration depending on the operating
mode selected).
Enter the 1
5,00
Enter the 2
Enter the 3
st
bill values accepted (e.g. €5.00) and press
nd
bill values accepted (e.g. €10.00) and press
rd bill values accepted (e.g. €10.00) and press
35
to confirm.
to confirm.
to confirm.