Starting The System - Paytec Eagle User Manual

Starting the system

Updated to firmware rev. 3.00.
When EAGLE is started, the following messages are displayed on the selector LCD.
-,--,--
firmware revision;
Euro
Euro-configured system (the message is not displayed for no/Euro systems);
CAL calibrating system...;
P6000
connecting with P6000...;
0,00
starting credit, system ready.
No link
This message is displayed when the serial link with Vending Machine has been cut (e.g.
the VM is out of service).
The entire sequence of messages is displayed for about 15 secs.
During the start-up phase both cashbox electromagnet and coin separator motor are activated.
NOTICE: starting from firmware rev.3.00 you can establish connection with P6000 even if the waiting time of
15 sec. is over: just press ESC four times on P6000. In order to cut connection with P6000, press
ESC four times or switch the changegiver OFF and ON again.
Firmware udpating messages
When giving power to EAGLE after its firmware has been upgraded with new parameters for coin measures, the
messages here below may be displayed to indicate a new setup on the calibration process.
dSPUP Updating DSC ...;
Ln - 50 updating counter DSC ... (wait, please)
Ln - 00
end
updating has been completed
SUCC DSC OK: wait till the system is automatically restarted
-CAL-
calibrating system... (wait till the message [ ] [ ] is displayed)
[ ] [ ] calibrating has been completed
After the system has been started, you can fill tubes.
Prices can be set with tube keypad on the faceplate.
Customized parameters (change to be given, tubes, key codes, free vend options, bonus menu...) can be
configured with a P6000, PayTools on Smartphone Android
Configurator").
The present guide contains the configuring procedures with keypad or a P6000 (or again with a Smartphone
™
Android after installing the APP PayTools, see p.19).
™
(with BT6000 Bluetooth
7
®
) or a PC (with "Paytec