Paytec Eagle User Manual page 32

Coin No.
AlloyPhase+: ----
Coin No.
D-AlloyPhase+: --
Coin No.
Enable DLXX:
Coin No.
DL70: ---
Coin No.
D-DL70:
Coin No.
DL10:
Coin No.
D-DL10:
Coin No.
Parameter F
Coin No.
D-Parameter F: --
Coin No.
Discrimination
Delta on coin parameters
"DELTAs" are tolerance values on coin parameters. When a coin is being programmed, the Delta is automatically
calculated for each parameter.
Delta values can be modified to adjust coin acceptance.
E.g.: when a parameter is 150 with a Delta of 10, that coin is recognized with a value between 140 and 160.
In the case of a poor acceptance, try programming the coins rejected in a free channel and compare their nominal
values with default ones.
When a new channel is added, tolerance on coin parameters can be increased.
Delta values cannot be modified in protected channels !
Parameter "Alloy Positive".
1
DO NOT MODIFY.
Tolerance on parameter "Alloy Positive".
1
DO NOT MODIFY.
DO NOT MODIFY.
1
Y Standard. Parameters "DLXX" are enabled.
N Parameters "DLXX" are NOT enabled.
Parameter "DL70"
1
The measure is taken by "Enable DLXX = Y"
DO NOT MODIFY.
Tolerance on parameter "DL70"
1
DO NOT MODIFY.
---
Parameter "DL10".
1
The measure is taken by "Enable DLXX = Y".
---
Do NOT MODIFY.
Tolerance on parameter "DL10".
1
--- DO NOT MODIFY.
Parameter "F".
1
DO NOT MODIFY.
---
Tolerance on parameter "F".
1
DO NOT MODIFY.
Advanced parameter for coin discrimination.
1
DO NOT MODIFY
0
32