Connectors Motherboard Cib1 - Paytec Eagle User Manual

Connectors motherboard CIB1

Motherboard CIB1 is the PCB interface for connections of the output cables to the VM or for connection to inner
connectors.
The motherboard is fixed on the housing wall (Fig.7)
Connectors CIB1
J2 J3
J7
JP2 This jumper permits to switch the function of connector J6-pin7.
Position 3-2: signal INHIBIT on pin7.
Position 1-2: UVcc = 34V DC (nom.) on pin7.
UVcc depends on the power supplied by the VM (e.g. by an input voltage of 24VAC on J6-pin7, you have a rectified
and filtered voltage of about 34VDC (UVcc)).
Here below the diagram of the signals for connector J6 and jumper JP2.
J5
J4
J10
J8 J9
J1
J12
Fig.7A
Connectors
J6
1
J1 Flat cable motherboard MCB1 coin selector
2
J2 AC/DC Vin 24V nom.
3
JP2
J3 Serial EXE, BDV to VM
J4 Serial peripheral MDB
J5 Serial MDB Slave to VM
J6 Bill validator in parallel mode
J7 nc
J8 nc
J9 Paytec key reader
J10 External IrDA
J12 Flat cable motor motherboard CECB1
11
MOTHERBOARD CIB1
Fig.7