Programmer P6000 - Paytec Eagle User Manual

Programmer P6000

"P6000" is a palmtop designed to configure systems or for servicing functions. The tool must be plugged on the
4-pin connector on the faceplate (Fig.8). Cut power before plugging/unplugging the P6000 flat cable.
Entering function menu with P6000
Plug the P6000 on 4-pin connector on the faceplate with EAGLE OFF, then give power and wait till the access
password is required on P6000 display. Enter the password within 5 seconds and press
If the P6000 is disconnected, press ESC four times to establish connection with P6000 again. The changegiver
is restarted (the msg *restarting* is displayed on P6000). Enter the password again.
This procedure is valid starting from firmware rev. 3.00. For earlier revisions, it is necessary to switch the
changegiver OFF and ON again.
ENTER
PASSWORD: -----
* PAYTEC EAGLE *
* Vers.-.--.-- *
* PAYTEC EAGLE *
*SN 000000000000
Language :
English
00 General
Parameters
The essential parameters for a correct functioning of a changegiver are present in Fn00, 01, 03, 04, 09.
P6000 keypad
ENTER – enter a function menu
– confirm a setting
– scroll down parameters
ESC – press once to exit a function
– press 4 times to restart the changegiver
C Cancel
Scroll down function list
Scroll up function list
1 YES or 1.
Press 1 for "Y" (YES)
0 NO or 0.
Fig.8
Press 0 for "N" (NO)
Enter the password within 5 secs. and press
If the password is not entered within 5 secs., connection is cut with the P6000
and a new connection is established with VM.
EAGLE firmware revision.
Press .
Product Serial Number.
Press .
This message is displayed when the system is configured in two languages.
When the system is configured in one language, the message is not displayed.
Press .
Press to enter Fn00.
Press (next) or
and back to "ENTER PASSWORD"
(back) to scroll the function list.
18
to confirm.
to confirm.