Paytec Eagle User Manual page 26

After bill validator parameters have been set, enter Fn05 and enter bill values
Maximum value
Escrow ---,--
Without key, bills are accepted till the level "maximum credit cash" is reached and are routed to the
cashbox. After this level has been reached, bills are kept in escrow status when their value is not
higher than the "Max. value Escrow" set here.
E.g. with EURO: by max.value escrow = 10.00, the validator will accept €5 and €10 bills but
won't accept €20 bills.
When a bill is in escrow status, one the following conditions may occur:
a) when making a vend: if the bill is necessary to complete the payment, the bill is routed to the
cashbox, otherwise it is given back;
b) when inserting a key: the bill is accepted and its value is loaded on the key. If the key is not
enabled to be recharged, the bill is given back;
c) when pressing the lever escrow on the changegiver, the bill is given back.
The function escrow is inhibited in the following cases:
- the value set is "0.00" (zero);
- a key has already been inserted (the value of the bill is loaded on the key).
Bills always
enabled ?
Bill Validator
ON in Ex-Ch ?
Decimal Point
Position LCD
Maximum credit
Cashless: 10000
Maximum credit
cash: 10000
Display
OFF ?
Display ON
(10-250)secs.
Set this parameter when a bill validator MDB with function escrow is
connected to the changegiver EAGLE as a slave unit.
Set this option when a bill validator is connected, even in MDB.
N Bills are only accepted after a key has been inserted.
Y Bills are always accepted (with/without key inserted).
Set this option when a bill validator is connected, even in MDB.
N Bills are only accepted when the tubes are full.
Y Bills are also accepted when the tubes are empty (no change is
given, though).
Decimal point position on display.
0 = credit is displayed without decimals;
0
2 = credit is displayed with cents.
Euro-configured EAGLE = 2
Maximum credit that can be loaded on a key.
A key is also accepted with a higher credit when the check on max.
credit is not enabled (see Fn06).
Max. value = 65535 (€ 655.35).
Maximum credit accepted for payment with coins and/or bills in
multivend mode (see Fn01).
When the changegiver has been set in "single vend" mode, the max.
credit on key accepted by a changegiver corresponds to the value
of the max. price (see Fn04).
Max. value = 65535 (€ 655.35).
N LCD always ON with backlighting ON.
Y LCD ON but backlighting goes OFF after the time programmed.
Set the no. seconds after which the backlighting goes OFF.
During "setup" from keypad, the display is backlighted again.
0
26