Paytec Eagle User Manual page 24

Charger
mode ?
MDB-RS232
mode ?
In MDB-RS232 mode, EAGLE can be used as a payment system connected to serial port RS232 of a PC. RS232
mode requires protocol MDB (to be implemented on your PC).
MDB-RS232 enables "Bit Mode" to establish communication between Master (PC) and Slave unit (EAGLE). In
order to make "MDB-RS232" easier to implement on a PC, the "Bit Mode" has been replaced by a 20 msecs.
timeout (no more than 5ms in "idle" status must pass between a character and the next in the same frame). When
giving power (with MDB-RS232 activated), coins are inhibited until the activation command is transmitted from
PC.
MDB-RS232 being a special operating mode, please contact Payment Technologies S.r.l. for more info.
Machine code
12345678
Machine type
Currency
description
EUR = 978
Coins only with
key-card ?
Bill Validator
connected ?
N Charger mode inhibited.
Y Charger mode enabled: the changegiver is ready without serial line
(no Link). You simply have to give power.
Coins are accepted following the configuration set.
When a key reader is connected, set coin acceptance parameters
with/without key inserted.
N RS232 mode inhibited.
Y RS232 mode enabled with MDB protocol.
Enter machine identification number (1 to 9999999). This number
appears in the Audit file.
The code can be set from keypad (see p.69).
Enter a number (1 to 99) identifying machine type. This number is not
present on Audit printed reports but it appears on the list transmitted to
1
the PC.
EAGLE in EURO currency = 978.
Only EURO COINS / KEY are accepted.
978
The value "978" cannot be modified
When
their value is converted following the change rate set in Fn38. On the other
hand, "noEuro" keys are converted to "Euro" keys, but their value is converted
following the change rate set in Fn38.
Should the system memory be reset, currency description becomes "1".
For those countries that have not adopted the EURO, this option can be
configured with a code of your choice (except 978), or with the currency code
for the country identified by ISO4217.
Set this option when an MDB cashless reader or a Paytec key
reader has been connected to EAGLE.
N Coins are always accepted (no need to insert a key).
Select "N" when no key reader is connected.
Y Coins are only accepted after a key has been inserted.
Select "Y" when a bill validator in parallel mode has been connected on
J6 (9 pins).
Leave "N" if an MDB reader has been connected as an external unit.
N No bill validator in parallel mode is connected.
Y A bill validator in parallel mode is connected.
Contact Payment Technologies S.r.l. for the dedicated cable.
"noEuro" coins have been programmed, such coins are accepted but
24