Paytec Eagle User Manual page 79

Repositioning puller/ejector F in the case of a motor being stuck
The image here below (fig.14) shows puller F "from below": the puller is positioned completely forward but
the motor shaft nail is not in its correct position (see detail).
PULLER F
Fig.14
The motor shaft must rotate till its nail fits into the carving on the puller F and on till the puller is dragged
to the starting position. Press C more than once to cause the motor shaft to rotate in the correct direction
Keep on pressing C (short rotations of the motor shaft) till the puller reaches its correct position (Fig.16).
Fig.15
79
Detail of the motor shaft mail correctly
fitting in the carving of PULLER F
Fig.16