Draytek Vigor2862 Series User Manual page 930

T e l n e t C o m m
T e l n e t C o m m
This command allows you to Enable/Disable for each WAN to join auto load balance member.
S S y y n n t t a a x x
wan lb [wan1/wan2/...] on
wan lb [wan1/wan2/...] off
wan lb status
S y n t a x
S y n t a x
Parameter
wan1/wan2
on
off
status
E x a m p l
E x a m p
> wan lb status
WAN1: on
WAN2: on
WAN3: on
WAN4: on
WAN5: on
WAN6: on
WAN7: on
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure multi-VLAN for WAN and LAN. It supports pure bridge
mode (modem mode) between Ethernet WAN and LAN port 2~4.
S y n t a x
S y n t a x
wan mvlan [pvc_no/status/save/enable/disable] [on/off/clear/tag tag_no] [service
type/vlan priority] [px ... ]
wan mvlan keeptag[pvc_no][on/off]
S y n t a x
S y n t a x
Parameter
pvc_no
status
save
enable/disable
on/off
clear
tag tag_no
914
a n d : w a n l b
a n d : w a n l b
D e s c r i p t i o n
D e s c r i p t i o n
Description
Specify which WAN will be applied with load balance.
Make WAN interface as the member of load balance.
Cancel WAN interface as the member of load balance.
Show the current status.
e
l e
a n d : w a n m v l a n
a n d : w a n m v l a n
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means index number of PVC. There are 10 PVC, 0(Channel-1) to
9(Channel-9) allowed to be configured.
However, bridge mode can be set on PVC number 2 to 9.
It means to display the whole Bridge status.
It means to save the configuration into flash of Vigor router.
It means to enable/disable the Multi-VLAN function.
It means to turn on/off bridge mode for the specific channel.
It means to turn off/clear the port.
It means to tag a number for the VLAN.
Vigor2862 Series User's Guide