Draytek Vigor2862 Series User Manual page 853

-v
-c
-x
-k
ppa n – used in QoS or specific host
-l <rule>
-h <host>
-s <start port>
-e <end
E E x x a a m m p p l
> ppa -m 1 -p 1 -b 0
Set ok! The PPA mode is Auto
% You need to set the Manual mode first !
%TWO way accleration is disable
> ppa –v
% PPA mode is Auto
%PPA Protocol TCP 1, UDP 0
%PPA two way disable
%PPA time is 10
%PPA range is 192
%PPA LAN entries 0
%PPA WAN entries 0
DrayTek> ppa -x
WAN1 status : Enable
WAN1 phy_type : ADSL
WAN1 session check = NULL
WAN2 status : Enable
WAN2 phy_type : ETHERNET
WAN2 session check = hw_acc_for_ether_XDSL
T e l n e t C o m m
T e l n e t C o m m
This command allows you to view current status (interface and driver) of USB printer.
S y n t a x
S y n t a x
prn status
prn debug
E x a m p l
E x a m p
> prn status
Interface: USB bus 2.0
Printer: NotReady
> prn debug
conn[0] :
none
Vigor2862 Series User's Guide
port>
l e e
a n d : p r n
a n d : p r n
e
l e
Show PPA_WAN_Table and PPA_LAN_Table for reference.
Clean all settings.
Show hardware acceleration information.
Clean the PPA table.
Specify an index number of rule profile for QoS mode.
Type an IP address for Specific Host mode.
Specify a starting port number for Specific Host mode.
Specify an ending port number for Specific Host mode
837