Draytek Vigor2862 Series User Manual page 88

Active When
VLAN Tag insertion
After finished the above settings, click OK to save the settings.
72
activated always.
Load Balance: Check this box to enable auto load balance
function for such WAN interface.
When the data traffic is large, the WAN interface with the
function enabled will balance the data transmission
automatically among all of the WAN interfaces in
connection status.
Failover – Choose it to make the WAN connection as a
backup connection.

WAN Failure – When the active WAN failed, such WAN
will be activated as the main network connection.

Traffic Threshold – When the data traffic of active
WAN reaches the traffic threshold (specified here),
the failover WAN will be enabled automatically to
share the overloaded data traffic.
If you choose Failover as the Active Mode, Active When
will appear. Please specify which WAN will be the Backup
interface.
Any of the selected WAN disconnect – Such backup WAN
will be activated when any master WAN interface
disconnects.
All of the selected WAN disconnect – Such backup WAN will
be activated only when all master WAN interfaces
disconnect.
Check boxes for WAN1 to WAN4 – Specify the WAN
interface by checking the WAN box.
Such feature is offered to the user with the environment
supporting IEEE_802.1ad. In which, service is used for outer
tag; customer is used for inner tag.
It is available only when Ethernet is selected as Physical
Mode.
Enable – Enable the function of VLAN with tag.
The router will add specific VLAN number to all packets on
the WAN while sending them out.
Please type the tag value and specify the priority for the
packets sending by WAN1.
Disable – Disable the function of VLAN with tag.
Tag value – Type the value as the VLAN ID number. The
range is form 0 to 4095.
Priority – Type the packet priority number for such VLAN.
The range is from 0 to 7.
Vigor2862 Series User's Guide