Draytek Vigor2862 Series User Manual page 928

wms
E E x x a a m m p p l
> wan lte band
Access technology : LTE
Access band information : E-UTRA Op Band 3
Interfere with 2.4G WLAN : NO
Active channel: 1725
>wan lte stus
Status: Operational. (Online)
Access Tech: LTE
Band: E-UTRA Op Band 3
ISP: Chunghwa
MCC: 466, MNC: 92, LAC: 65534, Cell ID: 81023501
Max Channel TX Rate: 50000000 bps
Max Channel RX Rate: 100000000 bps
IMEI: 356318040749422
IMSI: 466924200859808
RSSI: -61 dBm
Unread SMS: 4
SMSC address: +886932400821
SMS service status : Ready
Number of SMS sent : 0
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure WAN connection detection. When Ping Detection is
enabled (for Static IP or DHCP or PPPoE mode), Router pings specified IP addresses to detect
the WAN connection.
S y n t a x
S y n t a x
wan detect [wan1/wan2/wan3/wan4][on/off/always_on]
wan detect [wan1/wan2/wan3/wan4] target [ip addr]
wan detect [wan1/wan2/wan3/wan4] target2[ip addr]
wan detect [wan1/wan2/wan3/wan4] target_gw [1/0]
wan detect [wan1/wan2/wan3/wan4] ttl [value]
wan detect [wan1/wan2/wan3/wan4] interval [interval]
wan detect [wan1/wan2/wan3/wan4] retry [retry]
wan detect status
S y n t a x
S y n t a x
Parameter
on
off
always_on
target
Target2
912
This command is for RD debug only. We use it to test new USB
modems. Please don't use it without our advice.
l e e
a n d : w a n d e t e c t
a n d : w a n d e t e c t
D e s c r i p t i o n
D e s c r i p t i o n
Description
Enable ping detection. The IP address of the target shall be set.
Enable ARP detection (default).
Disable link detect, always connected(only support static IP)
Set the ping target.
Set the secondary ping target.
Vigor2862 Series User's Guide