Draytek Vigor2862 Series User Manual page 107

RIP Protocol
Bridge Mode
MAC Address
After finishing all the settings here, please click OK to activate them.
Vigor2862 Series User's Guide
 Path MTU to – Type the IP address as the specific
transmit path.
MTU size start from – Determine the starting point

value of the packet. Default setting is 1500.
MTU reduce size by– It determines the decreasing size

of MTU value. For example, the number specified in
this field is "8". The maximum MTU size is "1500".
After clicking the "detect" button, the system will
calculate and get the suitable MTU value such as 1500,
1492, 1484 and etc., automatically.
Detect – Click it to detect a suitable MTU value

 Accept – After clicking it, the detected value will be
displayed in the field of MTU.
Routing Information Protocol is abbreviated as RIP （RFC1058）
specifying how routers exchange routing tables information.
Click Enable RIP for activating this function.
Enable Bridge Mode - If the function is enabled, the router
will work as a bridge modem. Yet, the incoming packets with
VLAN tags will be discarded.
Enable Full Bridge Mode – If the function is enabled, the
router will work as a bridge modem which is able to forward
incoming packets with VLAN tags.
Bridge Subnet – Make a bridge between the selected

LAN subnet and such WAN interface.
Default MAC Address – Type in MAC address for the router.
You can use Default MAC Address or specify another MAC
address for your necessity.
Specify a MAC Address – Type in the MAC address for the
router manually.
91