Draytek Vigor2862 Series User Manual page 115

PPP Setup
IP Address Assignment
Method(IPCP)
WAN IP Network Settings
After finishing all the settings here, please click OK to activate them.
Vigor2862 Series User's Guide
path.
Click Detect to open the following dialog.
 Path MTU to – Type the IP address as the specific
transmit path.
MTU size start from – Determine the starting point

value of the packet. Default setting is 1500.
 MTU reduce size by– It determines the decreasing size
of MTU value. For example, the number specified in
this field is "8". The maximum MTU size is "1500".
After clicking the "detect" button, the system will
calculate and get the suitable MTU value such as 1500,
1492, 1484 and etc., automatically.
 Detect – Click it to detect a suitable MTU value
 Accept – After clicking it, the detected value will be
displayed in the field of MTU.
PPP Authentication - Select PAP only or PAP or CHAP for
PPP.
Idle Timeout - Set the timeout for breaking down the
Internet after passing through the time without any action.
WAN IP Alias - If you have multiple public IP addresses and
would like to utilize them on the WAN interface, please use
WAN IP Alias. You can set up to 32 public IP addresses other
than the current one you are using.
Fixed IP - Usually ISP dynamically assigns IP address to you
each time you connect to it and request. In some case, your
ISP provides service to always assign you the same IP address
whenever you request. In this case, you can fill in this IP
address in the Fixed IP field. Please contact your ISP before
you want to use this function. Click Yes to use this function
and type in a fixed IP address in the box.
Fixed IP Address -Type a fixed IP address.
Obtain an IP address automatically – Click this button to
obtain the IP address automatically.
Specify an IP address – Click this radio button to specify
some data.

IP Address – Type the IP address.

Subnet Mask – Type the subnet mask.
99