Draytek Vigor2862 Series User Manual page 809

-e<parameter>
E x a m p l
E x a m p
> ip6 dhcp server -d FF02::1
> ip6 dhcp server -i ff02::1
> ip6 dhcp server -x ff02::3
> ip6 dhcp server -a
% Interface LAN has following DHCPv6 server settings:
% DHCPv6 server disabled
% maximum address of the pool: FF02::3
% minimum address of the pool: FF02::1
% 1st DNS IPv6 Addr: FF02::1
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure settings for accessing Internet.
S y n t a x
S y n t a x
ip6 internet -W n -M n [-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
-W n
-M n
[<command>
<parameter>|...]
-m n
-u <username>
Vigor2862 Series User's Guide
0: Disable
It means to enable or disable the DHCPv6 server.
1: Enable
0: Disable
e
l e
a n d : i p 6 i n t e r n e t
a n d : i p 6 i n t e r n e t
D e s c r i p t i o n
D e s c r i p t i o n
Description
W means to set WAN interface and n means different selections.
Default is WAN1.
n=1: WAN1
n=2: WAN2
n=3: WAN3
.
.
n=X: WANx
M means to set Internet Access Mode (Mandatory) and n means
different modes (represented by 0 – 5)
n= 0: Offline,
n=1: PPP,
n=2: TSPC,
n=3: AICCU,
n=4: DHCPv6,
n=5: Static
n=6:6in4-Static
n=7:6rd
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
It means to set IPv6 MTU.
N = any value (0 means "unspecified").
It means to set Username.
793