Draytek Vigor2862 Series User Manual page 149

2. Configure the channel as follows,
(a)
(b)
(c)
(d)
(e)
3. Click OK to save the configuration, the configuration will be displayed on the main page.
And now you may connect the STB to the Bridged port to use the IPTV service.
Vigor2862 Series User's Guide
enable this channel
set WAN Type to the WAN interface that the service provider is on.
set up VPI and VCI if the WAN is an ADSL line.
enable Add VLAN Header and enter the VLAN Tag and Priority as the service
provider requires.
check Enable for Bridge Mode, and select the physical port member to which you're
going to connect the STB.
133