Ii-6-2 Load-Balance /Route Policy - Draytek Vigor2862 Series User Manual

I I - 6 - 2 L o
I I - 6 - 2 L o
It allows network administrator to manage the outbound traffic more specifically. The policy
set in Load-Balance/Route Policy always has higher priority than Default Route and Auto
Load Balance set in WAN >> Internet Access, and always has lower priority than the Firewall
Rules. Administrator may also define a priority to this policy.
This page lists all the policies and shows whether the policy is enabled/disabled, what are the
criteria to match, and through which the interface should the traffic to go if the criteria are
matched, and also its priority.
Available settings are explained as follows:
Item
Index
Enable
Protocol
Interface
Priority
Src IP Start
Src IP End
Dest IP Start
Dest IP End
Dest Port Start
Dest Port End
Move UP/Move Down
Wizard Mode
Vigor2862 Series User's Guide
a d - B a l a n c e / R o u
a d - B a l a n c e / R o u
Description
Click the number of index to access into the configuration
web page.
Check this box to enable this policy.
Display the protocol used for this policy.
Display the interface to send packets to once the policy is
matched.
Display the priority value for such route policy profile.
Display the IP address for the start of the source IP.
Display the IP address for the end of the source IP.
Display the IP address for the start of the destination IP.
Display the IP address for the end of the destination IP.
Display the IP address for the start of the destination port.
Display the IP address for the end of the destination port.
Use Up or Down link to move the order of the policy.
Allow to configure frequently used (simple and basic)
settings of route policy via three setting pages.
t e P o l i c y
t e P o l i c y
253