3onedata NP318T-8DI User Manual page 9

Before making remote configuration, make sure that the route between the

computer and the switch is reachable.
Before making a local configuration, make sure that the IP address of the

computer and the serial server are on the same subnet.
Note:
When the serial server is first configured. If it is configured locally, make sure the current
computer network segment is 1.
For example, suppose that the IP address of the computer is 192.168.5.60, need to
change the IP address of the network segment "5" to "1"
Operation steps
The steps are as follows:
Step 1 Open "Control panel > Network connection > Local area connection > Properties >
Internet protocol version (TCP/IPv4) Properties".
Step 2 Change the "5" selected by the red frame in the figure to "1".
Step 3 Click "OK".
Step 4 End.
3onedata proprietary and confidential
Copyright © 3onedata Co., Ltd.
User Manual
2