3onedata NP318T-8DI User Manual page 31

Interface Elements
Send_msg
Connection control
Disconnection
control
3onedata proprietary and confidential
Copyright © 3onedata Co., Ltd.
Description
Note:
When password verification is enabled, only users with "admin"
account privileges can send / receive messages using this device.
The first data sent by the peer server to the device defaults to

the check password.
Verification password is "admin" account password.

If the password is entered incorrectly, re-establish the

connection and then re-enter the password.
The information sent after the device is connected to the
peer server. The options are:
Ipaddr: After the connection is successful, send the IP

address of the device to the remote server.
Devicename: After the connection is successful, send

the devicename of the device to the remote server.
turnoff: After the connection is successful, no

information is sent to the peer server.
Select how the serial server initiates a connection request.
The options are:
Always: Immediately after the system is started, it tries

to establish a connection with the target host and
automatically reconnects the target host after the
connection is disconnected.
Char: Automatically connects to the target host when

receiving data from the serial port.
DSROn: Automatically connects to the target host when

the DSR signal is detected.
DCDOn: Automatically connects to the target host

when the DCD signal is detected.
Select how the serial server is disconnected. The options
are:
None: Never shut down the network connection

automatically.
DSROff: Automatically shuts down the network

connection when the DSR signal is detected invalid.
DCDOff: Automatically shuts down the network

connection when the DCD signal is detected invalid.
Idle: If the idle timeout time is greater than 0, the

system will automatically shut down TCP connections
that do not have any data send and receive activity for a
User Manual
24