Standards - Kontron CP6002 User Manual

CP6002
1.7

Standards

The board complies with the requirements of the following standards:
Table 1-3: Standards for the CP6002
TYPE ASPECT
CE Emission
Immission
Electrical Safety
Mechanical Mechanical Dimen-
sions
Environmental Climatic Humidity
WEEE
RoHS
Vibration
(Sinusoidal)
Single Shock
Note ...
Kontron performs comprehensive environmental testing of its products in accor-
dance with applicable standards.
Customers desiring to perform further environmental testing of Kontron prod-
ucts must contact Kontron for assistance prior to performing any such testing.
This is necessary, as it is possible that environmental testing can be destructive
when not performed in accordance with the applicable specifications.
In particular, for example, boards without conformal coating must not be
exposed to a change of temperature exceeding 1K/minute, averaged over a
period of not more than five minutes. Otherwise, condensation may cause irre-
versible damage, especially when the board is powered up again.
Kontron does not accept any responsibility for damage to products resulting
from destructive environmental testing.
ID 1036-6431, Rev. 2.0
STANDARD
EN55022 --
EN61000-6-3
EN55024 --
EN61000-6-2
EN60950-1 --
IEEE 1101.10 --
IEC60068-2-78 --
Directive 2002/96/EC Waste electrical and electronic equipment
Directive 2002/95/EC Restriction of the use of certain hazardous
substances in electrical and electronic
equipment
TBD TBD
TBD TBD
Introduction
REMARKS
Page 1 - 19