Table of Contents
Advertisement
Install the front endcap assembly using the same procedure used to install the rear endcap assembly . Do not forget the endcap
brace . (See pages 6-8) On the front faceplate, use the plastic 3/8" ribbed push in rivets to fill the four 3/8" holes .
Install all of the tarp bows . Use (4) 1/4" x 3" hex bolts and (4) 1/4" serrated flange nuts for each bow .
NOTE: If your tightening lip is centered and there are no holes visible through your lip lock and sideboard, holes
will need to be drilled wherever there are slots in the lip lock. Use a 1/4" drill bit to accomplish this. Now make sure that
all of the tarp bows are perpendicular to the auger side of the cart and drill 1/4" holes through the sideboards. This should
only be the case on later model grain carts.
Installing the Front Endcap
Installing Tarp Bows
9
Advertisement
Table of Contents
