Table of Contents
Advertisement
Incorrect
Figure 1
1 .
When the tarp is in closed position roll the tarp up to the tightening lip so the tarp is taught .
2 .
Open the tarp .
3 .
If the tarp is rolling at an angle (Figure 1), close the tarp until it's in the same position as Figure 3 .
4 .
Now insert a 5" section of 1/8" self-adhesive rubber into the rear end of the roll tube . Figure 4
5 .
Repeat steps 1-4 until the tarp rolls correctly .
NOTE: If the tarp is not rolling in the right direction when the open/close buttons are pushed, switch the black and
yellow wires that are connected to M1 and M2 of the motor.
Figure 3
Aligning the Tarp/Troubleshooting
Correct
Figure 2
1/8" Self Adhesive Rubber
Figure 4
21
Advertisement
Table of Contents
