Installing Rear Endcap - J&M 525 Setup Manual

Place the Rear Endcap Assembly onto the back of the grain cart . Slide the endcap to the right until it makes contact with the corner
bracket .
Using a 1/4" drill bit, drill through the hole closest to the corner bracket . Once drilled, fasten with a 1/4" x 1/2" serrated flange hex
bolt and nut . Now drill the opposite side and fasten with a 1/4" x 1/2" hex bolt and serrated flange nut .
Now drill the remaining holes for the rear endcap . All the holes that need drilled run horizontally with the hole that was just
drilled .
Note: While drilling, pull up on the front of the endcap so the faceplate will lie parallel with the rear grain cart
wall.
Place 1/4" x 1/2" hex bolts and serrated flange nuts in the remaining holes and tighten the hardware once finished .
6
Installing the Rear Endcap
NOTE: While drilling, pull up on the front of the endcap
so the faceplate will lie parallel with the rear grain cart
wall.
Sideboard Corner