Pull the tightening lip tight against the opposite auger side of the grain cart . Using a 1/4" bit, drill through the hole on the top of
the endcap . Fasten the endcap by using a 1/4" x 1-1/2" bolt and 1/4" serrated flange nut . Tighten the bolt . Now go to the other end
of the endcap and repeat the same procedure .
Auger Side
Rear of Cart
Now place (3) 3/8" J-bolts into the three holes closest to the auger side in the rear endcap . Fasten the J-bolts with (3)
3/8" locknuts . Use the plastic 3/8" ribbed push in rivet to plug the remaining hole . Leaner carts use four J-bolts and
wont require a ribbed push in rivet .
NOTE: DO NOT tighten past flush.
8
Tightening Rear Endcap
Installing J-Bolts
J-Bolts
Lock Nuts
Opposite Auger Side