Table of Contents
Advertisement
Switchboard
Position the Electric Roll Tarp Switch Mount on the front auger side leg in a position that it will not interfere with any other
component of the grain cart and so that the power cables will reach from the battery to the Switchboard . Use the electric roll tarp
switch mount as a guided to mark the two holes . Once marked, drill (2) 9/32" holes .
Black Spacers
Attach both of the relays to the electric roll tarp switch mount using a 1" x 1/4" hex bolt and 1/4" serrated flange hex nut . Attach
the 35 amp breaker with (2) 8-32 x 5/8" phillips pan head bolts . Using (2) 10-24 x 1" slotted hex head bolt and (2) 10-24 serrated
flange hex nuts attach the 20 amp breaker and snap the 12V to 12V battery charger into the bracket .
Now install the assembled mounting bracket using (2) 1/4" x 3-1/2" hex bolts, (2) 1/4" locking hex nuts and (2) 2" black spacers .
Relays
35 Amp Breaker
Battery Charger
1" x 1/4" hex bolt
20 Amp Breaker
Black Spacers
Now make all of the connections using the provided wires and hardware according to the schematic on the next page .
19
Advertisement
Table of Contents
