Hanger Bracket Locations - J&M 525 Setup Manual

Hanger Bracket
NOTE: If you are installing the optional Electric Roll Tarp skip to Tightening Lip on pg. 5.
Place the hanger bracket with the four hole pattern, positioned at the top, in the center of the rear wall on the cart . Keep the hanger bracket as low as
possible on the rear wall . Mark the four holes then drill with a 7/16" bit . See figure bellow for specific model . For 1312, 1326, and 1522 models, the spring
return in the rear of the cart will obstruct where the hanger brackets are supposed to be installed . Instead use a bent hanger bracket (JM0048492 ) and
install directly under the sideboard at the top of the angled shell .
Model 1000 to 1412
Model 525 to 875
Model 1122 to 1522 Leaner
Model X2431 and GC-31T International
Rear Runner
NOTE: All Leaner models have (2) hanger brackets. Center the hanger brackets with the rear runners and place the bracket as low as possible on the rear wall.
GC-24T International Drag Cart Series
4