Table of Contents
Advertisement
Install the roll tarp hanger bracket . Use (4) 3/8"-16 x 1" Gr5 Z serrated flange hex bolts and (4) 3/8"-16 Gr5 Z serrated flange hex
nuts to attach the hanger bracket to the rear end panel brace . Tighten the hardware once installed .
Next install the hanger bracket hook and the rubber flap . Use a 1/2"-13 x 1-1/4" Gr5 Z hex bolt and a 1/2"-13 x 1-1/4" Gr5 Z centerlock
hex nut to attach the hook and flap to the hanger bracket . Tighten the hardware once installed .
Note: Make sure that hanger bracket hook is facing towards the cart when installed.
Install the roll tarp hanger bracket . Use (4) M10-1 . 5 x 25 Gr8 . 8 YZ serrated flange hex bolts and (4) M10-1 . 5 Gr8 . 8 YZ serrated flange
hex nuts to attach the hanger bracket to the rear end panel brace . Tighten the hardware once installed .
Next install the hanger bracket hook and the rubber flap . Use a M12-1 . 7 5 x 50 Gr8 . 8 YZ hex bolt and a M12-1 . 7 5 Gr8 . 8 YZ nylon lock-
ing hex nut to attach the hook and flap to the hanger bracket . Tighten the hardware once installed .
Note: Make sure that hanger bracket hook is facing towards the cart when installed.
Center the tightening lip from the front to the rear of the cart on the opposite auger side of the grain cart . Depending on the
length of your grain cart, there maybe a total of two tightening lips . If there is two, position the inside edge of each tightening lip
to the center of the grain cart . Make sure that the tightening lip is flush to the inside of the sideboard . The holes may already be
pre-drilled for installation or they may need to be drilled out with a 1/4" drill bit . Use a pair of C-clamp vise grips to temporarily
hold the tightening lip in place . Bolts will be installed in a later step .
Hanger Bracket
Standard Grain Carts
International Grain Carts
Flapper
Hanger Bracket
Tightening Lip
5
Advertisement
Table of Contents
