Installing Cable Clamps - J&M 525 Setup Manual

Using a cable clamp, feed one end of the cable through the cable clamp, make a small loop, then tighten the cable . Do this with all three cables .
NOTE: Make sure that the base of the clip bears on the live end of the rope and the "U" of the
bolt bears on the dead end.
Now thread all three cables through the front endcap pulling the end without the cable clamps through first .
NOTE: Make sure to pull from front to back.
Next guide the cables over the arched bows and thread them through the existing holes on the rear endcap . Now feed the
cables through the cable clamps .
NOTE: Make sure that the base of the clip bears on the live end of the rope and the "U" of the
bolt bears on the dead end.
Place the loop into the J-bolt . Use a vise grip to pull on the cable . Pull the cable tight . To remove all slack from the cable, aggres-
sively tap the cable while applying tension with the vise grips . Then tighten the cable clamp . Once the clamps are tightened,
tighten the J-bolts . Insert a wrench into the hook of the J-bolt and tighten the nut .
10

Installing Cable Clamps

Live End
Dead End
Use wrench or bolt to hold the J-bolt while tightening.