Table of Contents
Advertisement
Remove the Knuckle from the roll tube if previously installed .
Un-tighten both 3/8" locknuts, then pull the knuckle away
from the tarp . Keep knuckle and crank handle .
The Spring return on the rear of the cart doesn't need to be removed .
Place the electric roll tarp mount in the middle of rear slope as far up as it can go . Mark and drill (6) 7-16" holes . Attach the mount
to the grain cart using (6) 3/8"x 1" serrated flange hex nuts and bolts . Tighten hardware once installed .
Removing Parts (if previously installed)
Electric Roll Tarp Mount
Un-install the hanger bracket if previously installed . Re-
move the (4) 3/8" x 1" serrated flange hex bolts and nuts
then remove the hanger bracket from the grain cart .
Install the bolts back into their original holes . Keep the
hanger bracket .
17
Advertisement
Table of Contents
