Table of Contents
Advertisement
Place the spring return as close to the front endcap and butt the side of the spring return, with the cable loop, against the welds
on the corner of the grain cart .
NOTE: For single auger cart make sure that the spring return is level with the ground and that the spring return is
not hindered by any part of the cart. The exception to this rule is the 32 series cart. They have the spring return
lined up with top of the cart.
Use a 1/4" drill bit to make your first hole . Then fasten the spring return to the cart using 1/4" x 3" self tapping screws . Next drill
through the remaining holes and insert the self tapping screws . Repeat process for back side of grain cart, installing the spring
return on the opposite auger side .
Installing the Spring Return
Cable Loop
11
Advertisement
Table of Contents
